RSS feed
a66b7574
– Jean-Marc Valin <
[email protected]>
authored
on 2011/01/10 08:21
Defines MAX_FINE_BITS to ensure that we're using the same value everywhere
9d2d0510
– Jean-Marc Valin <
[email protected]>
authored
on 2011/01/10 07:45
Using tell() rather than log2_frac() to compute qalloc
d9f6ec3f
– Jean-Marc Valin <
[email protected]>
authored
on 2011/01/10 05:52
Changes the N=2 stereo case to use the same sign convention as N=1
dc6d69e6
– Jean-Marc Valin <
[email protected]>
authored
on 2010/12/20 20:04
Ordering Hadamard frequencies when increasing the time-resolution.
034efa52
– Jean-Marc Valin <
[email protected]>
authored
on 2010/12/20 19:19
Tuning the dynamic allocation probability and increment
6ba0b350
– Jean-Marc Valin <
[email protected]>
authored
on 2010/12/20 06:40
Being a bit more careful about enabling the post-filter
6e4b9dc0
– Jean-Marc Valin <
[email protected]>
authored
on 2010/12/19 16:36
Turning noise filling back on for cases where we have no data to fold with
8e31ab3d
– Jean-Marc Valin <
[email protected]>
authored
on 2010/12/16 11:45
Making lower sampling rates use the same allocation table
8e447678
– Gregory Maxwell <
[email protected]>
authored
and Jean-Marc Valin <
[email protected]>
committed
on 2010/12/16 09:22
Terminate the coding of skip bits at the last dynalloc boosted band. Otherwise the bitstream allows non-sensible behavior by the encoder (dynallocing bits into a band and then skipping it). This reduces skip bit overhead by about 2-3% at moderate bitrates with the current encoder.
034172ba
– Jean-Marc Valin <
[email protected]>
authored
on 2010/12/16 09:40
Making the encoder fail less often at stupidly low bit-rates
ffe10574
– Jean-Marc Valin <
[email protected]>
authored
on 2010/12/14 19:36
Tim just rewrote half of the bit allocator -- hope it works now
70d30ffc
– Jean-Marc Valin <
[email protected]>
authored
on 2010/12/13 08:50
Using overlap=shortMdctSize even for 2.5 ms frames.
546dfa19
– Jean-Marc Valin <
[email protected]>
authored
on 2010/12/10 12:18
Adapting the allocation trim based on the spectral tilt
dfd6e714
– Jean-Marc Valin <
[email protected]>
authored
on 2010/12/09 18:23
Adding some hysteresis on the folding threshold frequency
85bbab0b
– Jean-Marc Valin <
[email protected]>
authored
on 2010/12/09 10:23
Fixes a fixed-point overflow in stereo angle calculation
2b747c98
– Jean-Marc Valin <
[email protected]>
authored
on 2010/12/08 06:06
Simplifying the allocation code and making sure both channels get a bit
9faf7408
– Jean-Marc Valin <
[email protected]>
authored
on 2010/12/04 05:27
Keeping the allocation of the intensity-codec bands
a4badac9
– Jean-Marc Valin <
[email protected]>
authored
on 2010/12/03 10:20
Making VBR slightly exceed the budget rather than fail
30165bba
– Jean-Marc Valin <
[email protected]>
authored
on 2010/12/03 09:35
Fixing the most obvious problems with the VBR code
e5e9aa79
– Jean-Marc Valin <
[email protected]>
authored
on 2010/12/02 11:09
Fixes some side-information rate control issues in VBR mode
1bfa18cb
– Jean-Marc Valin <
[email protected]>
authored
on 2010/12/01 11:11
Fix totally broken bit allocation for non-mainstream modes (e.g. powers of two).
dd4bf63a
– Jean-Marc Valin <
[email protected]>
authored
on 2010/11/30 10:31
Tuning higher bit-rate to behave a bit more like Vorbis.
128d0c1c
– Jean-Marc Valin <
[email protected]>
authored
on 2010/11/24 12:43
Tuning the allocation trim_offset for shorter frames
1ad93cf4
– Jean-Marc Valin <
[email protected]>
authored
on 2010/11/06 18:02
Fixes several fixed-point overflows in the PLC code
d7231dd1
– Jean-Marc Valin <
[email protected]>
authored
on 2010/11/06 16:30
Giving up on reusing the saved overlap in the PLC
Next